Welcome To our shop !

Raker 24V 3W 1 Way Exterior LED Inground Light

$36.8 $46
SKU: KO80391094681
Availability: in Stock

The Raker G13 is a 62mm one-way inground light in black 24V, 3W giving 8lm at 3000K,CRI above 95, IP65. Two things to settle before you specify it.No load rating…

Qty:

The Raker G13 is a 62mm one-way inground light in black 24V, 3W giving 8lm at 3000K,CRI above 95, IP65.

Two things to settle before you specify it.

  • No load rating is recorded. Nothing in any source says whether the Raker can bewalked on or driven over the first question about a light setflush into the ground. Treat it as a garden-bed and edge fitting, andask us before putting it in a trafficked path or a driveway. We are askingTelbix.
  • It is IP65, not IP67. Jet-rated, not immersion-rated andan inground fitting sits exactly where water pools after rain. Set it where theground drains.
One-way a directional grazing light

The G13 throws through a single aperture, so all of its light goesone way. That makes it the version for lightinga wall, a step riser, a fence or a tree trunk from below, where a two-way or four-wayfitting would throw half its output into empty air.

8 lumens, and that is deliberate. Thetwo-way version gives 14lm from the same 3W almost exactly doublefor double the apertures, which is the two fittings confirming each other. Theaperture count sets the output; the LED is the same.

This is a grazing light: set close to a surface itrakes across texture and makes brick, stone and timber read as material.Set out in the open it will do very little. If you want to uplight a tree properly, you want aspike ask us about the Rilto.

CRI above 95 and on this fitting it is the whole point

Equal highest in this catalogue. A grazing light’s entire job is toreveal the surface it is aimed at, at close range, and colour rendering is whatdecides whether it succeeds: at CRI 80 brick goes brown-grey and sandstone goes flat;at 95 the material looks like itself.

Nothing on our page mentioned it on a fitting where it is the specification thatmatters most.

24 volts a transformer is required and is notsupplied. It must sit somewhere dry, be sized for the whole run and be wired by anelectrician. We stock a 24V 60W and a 200W outdoor unit; at3W each, the 60W drives a long run.Tell us your layout and we will size it.

62mm across, 56mm cutout

62mm wide, 85mm deep, into a 56mm cutout, at0.22kg, with 1,000mm of cable. Thecutout is recorded worth noting, because several recessed fittings in thiscatalogue do not record theirs. The joint must sit in a dry, accessible housingwithin a metre; plan that before the paving or the mulch goes down.

One of three distributions

One-way (this), two-way and four-way. Choose bywhere the light needs to go, not by brightness: they all draw3W and the output simply follows the number of apertures.

Not dimmable, LED integrated and included.ClassIII low voltage, so the cable through your beds is low voltage safer around spades and roots, and easy to extend later.

Where it works
  • Grazing walls, fences, step risers and tree trunks from below.
  • Close to a surface, where CRI 95 reveals texture.
  • Garden beds, in runs on one transformer.
  • Ground that drains IP65 is not immersion-rated.
  • No load rating recorded. Ask us before a trafficked path.
Specifying it

62mm across by 85mm deep, cutout56mm, cable 1,000mm,0.22kg, in aluminium and glass, black. Integrated3W LED giving 8lm at 3000K through asingle aperture, included,CRI>95, not dimmable.24V a transformer is REQUIRED and is not supplied.ClassIII low voltage,IP65 jet-rated, NOT immersion-rated; set it where the ground drains.Load rating not recorded ask us. Warranty is three years, as a replacementwarranty.

Supplied and supported by Lights For You.

Questions

Can I walk on it or drive over it?

No source records a load rating, which on a flush inground fitting is the first question. Treat it as a garden-bed and edge fitting and ask us before putting it in a trafficked path or a driveway. We are asking Telbix.

Is IP65 enough for an inground light?

It is jet-rated but not immersion-rated IP67 adds that and an inground fitting sits exactly where water pools after rain. Set it where the ground drains.

Why only 8 lumens?

Because it is a grazing light, not an illuminator, and it throws through a single aperture. The two-way version gives 14lm from the same 3W almost exactly double for double the apertures. Set close to a surface it rakes across texture and makes brick, stone and timber read as material; out in the open it will do very little.

One-way, two-way or four-way?

Choose by where the light needs to go, not by brightness they all draw 3W and the output simply follows the aperture count. One-way for a wall, a riser, a fence or a trunk; two-way to wash along a path; four-way for an open position.

Why does CRI matter here?

Because a grazing lights whole job is to reveal the surface it is aimed at, close up. At CRI 80 brick goes brown-grey and sandstone goes flat; at 95 equal highest in this catalogue the material looks like itself.

Do I need a transformer?

Yes, and none is supplied. We stock a 24V 60W and a 200W outdoor unit; at 3W each the 60W drives a long run. Tell us your layout and we will size it.

What size hole does it need?

A 56mm cutout for a 62mm fitting 85mm deep, with 1 metre of cable. The joint must sit in a dry, accessible housing plan it before the paving or mulch goes down.

Only logged in customers who have purchased this product may leave a review.

Shipping policy for our store

We offer fast and reliable shipping worldwide. All orders are carefully packaged and shipped within 1–3 business days after payment confirmation.

  • Fast shipping within 1-3 business days
  • Free shipping on orders over $40
  • 30 days money back guarantee
  • 24/7 online customer support
  • Secure packaging & safe delivery

Standard shipping, expedited shipping and express delivery options are available at checkout. Delivery time depends on your destination country and local logistics.