Your shopping cart is empty!
The Module 16 is a recessed 12W LED downlight 880lm at 5000K cool white, CRI above 84,TRIAC dimmable, IP44, IC-4.
Two facts an installer needs, recorded and absent from ourpage.
And the cutout is recorded nowhere, on a recessed fitting it is the first thing an electrician asks for. Ask us before the ceiling is cutand we will confirm it with Telbix.
The warranty is in dispute, and we would rather tell you thanpick the flattering answer.
| Source | Warranty |
|---|---|
| The datasheet | 5 years |
| Our product record and page | 1 year |
| Its two sibling variants (MDL-16D-16W-930, MDL-16D-510G3) | 5 years, both |
Same module family, same construction, three variants and this one recorded at afifth of the term. We have published the shorter figure because we will notpromise a warranty we cannot verify, and asked Telbix to confirm.Ask us before you buy and we will have the answer on a whole-of-home downlightrun, four years of cover is not a detail.
Fixed at 5000K, and our page is right about what that suits:kitchens, laundries, garages and workspaces. 5000K isdaylight-cool, a clean slightly blue-white.
Where it does not belong: living rooms and bedrooms. A whole-housedownlight run in 5000K is the single commonest lighting regret it is excellent over abench and cold in a lounge. Ask us about the warm variants in the same module familyif the run covers both.
CRI above 84 better than the >80 most of thiscatalogue records. With cool light that is a useful pairing: in agarage, laundry or workshop you can judge colour properly, which is most of whattask light is for.
73lm/W. On a downlight grid that output isa normal domestic downlight bright enough for a kitchen at sensible spacing,and not so bright it needs to be spaced wide.
TRIAC dimming on an ordinary wall dimmer, which on a grid of downlights is worthhaving: a room lit by six fittings at full is a room you cannot soften.
The MDL range is a two-part system: aframe that stays in the ceiling and a module that makes the light andcan be changed without touching the plaster.
That is the reason to specify it. Most downlights are one sealed unit whenthe LED fails, the whole fitting comes out, and if the replacement has a different cutout you arepatching plasterboard. With a frame-and-module you swap the module: for a failure, or for adifferent colour temperature or beam, years later.
Check the pairing before you order. The MDL-613 frame in thiscatalogue takes a 90mm cutout, and we have not been given this module’s owndimensions. Tell us which frame you have or are buying and we will confirm the two gotogether that is exactly the sort of thing we would rather check than have youdiscover on site.
75mm deep, in aluminium whichis what carries the LED’s heat away, and the single thing that most determines how long a diodeactually lasts. 240V, running directly on mains with noseparate transformer.
75mm deep, in aluminium. Cutout and overall dimensions are not recorded ask us before the ceiling iscut. Integrated 12W COB LED giving 880lm at 5000K cool white fixed, included, CRI>84,TRIAC dimmable. 240V,ClassI earth required,IC-4 may be covered and abutted by insulation,IP44 bathrooms outside the shower zone. Warranty is published as ONE year; the datasheet says FIVE, and both sibling variantscarry five. Ask us before you buy.
Supplied and supported by Lights For You.
What is the warranty?
Our record and page say one year; the datasheet says five and its two sibling variants, the MDL-16D-16W-930 and the MDL-16D-510G3, both carry five years. Same module family, same construction, and this one recorded at a fifth of the term. We have published the shorter figure because we will not promise cover we cannot verify, and asked Telbix to confirm. Ask us before you buy: on a whole-of-home downlight run, four years is not a detail.
Can it be covered by ceiling insulation?
Yes it is IC-4, rated to be covered and abutted, so no clearance gap has to be maintained around it and none can be closed up later by someone in the roof. That was recorded and appeared nowhere on the page.
Can it go in a bathroom?
Outside the shower zone, yes it is IP44, protected against splashing water from any direction. Our page said only Usage: Indoor.
What size hole do I cut?
No source records it, on a recessed fitting and it is the first thing an electrician asks for. Ask us before the ceiling is cut and we will confirm it with Telbix.
Is 5000K right for my house?
For kitchens, laundries, garages and workspaces, yes. Not for living rooms or bedrooms a whole-house downlight run in 5000K is the commonest lighting regret, excellent over a bench and cold in a lounge. Ask us about the warm variants in the same module family if the run covers both.
Why buy a module rather than a whole downlight?
Because the module can be changed without touching the plaster for a failure, or for a different colour temperature or beam years later. Most downlights are one sealed unit: when the LED fails the whole fitting comes out, and if the replacement has a different cutout you are patching plasterboard.
Will it fit the MDL-613 frame?
Tell us which frame you have or are buying and we will confirm. The MDL-613 takes a 90mm cutout and we have not been given this modules own dimensions that is exactly the sort of thing we would rather check than have you discover on site.
Only logged in customers who have purchased this product may leave a review.
We offer fast and reliable shipping worldwide. All orders are carefully packaged and shipped within 1–3 business days after payment confirmation.
Standard shipping, expedited shipping and express delivery options are available at checkout. Delivery time depends on your destination country and local logistics.