Joiner to suit Linear Modules Profile

This is a joiner, to suit an aluminium profile.

It is a fitting accessory on its own. There is no LED strip in it, no channel and no driver – it is one of the parts that holds a profile run where it needs to be.

What it does

A joiner carries the profile around a corner or between two lengths while keeping the faces aligned. Butting two cut ends together freehand almost always leaves a step, and a step in a lit line is visible from anywhere in the room.

It also holds the geometry while the run is being fixed, which is the part that is hard to do by eye – an angle that looks right while everything is loose will not stay right once both sides are screwed down.

Ordering the right one

These parts are shaped to a particular profile and do not interchange. Confirm which profile it is listed against before ordering – the product title does not name one, and these parts are not interchangeable.

Count what the job needs from the length of the run rather than ordering a nominal few. Fixings are spaced along a run, so a longer profile needs proportionally more of them, and a channel fixed at too few points will show a visible sag or a wave in the line of light once it is switched on.

It is worth having one or two spare. These are the smallest components in a profile installation and the ones most easily mislaid on site, and a run left unfixed while a replacement is ordered rarely gets finished promptly.

Installing it

Fit these before the strip and the diffuser go in. Working on a channel that is already loaded means either working around the strip or taking it back out, and the adhesive backing on LED strip does not always survive a second attempt.

Check the run is straight and sitting flat as you go rather than at the end. A profile is rigid enough to hide a small misalignment while it is loose, and rigid enough to make it permanent once it is fixed.

Specifying and pricing this

This is part of the Havit Commercial range, which is priced on application rather than listed. Use the enquiry button on this page and we will come back with pricing for the quantity you need.

Components like this are ordered against a specific installation, so it is worth confirming the parent product and the quantity together. Send us the part number you are matching and we will confirm what suits it.

Confirm availability before a specification is issued. Commercial ranges change, and a product written into a drawing that is no longer stocked is a change order later, when it is far more expensive to fix.

Frequently asked questions

Is this a light?

No. It is a joiner – a mounting accessory. There is no LED strip, channel or driver with it.

Which profile does it suit?

The product title does not name one, so confirm it before ordering – these parts are shaped to a particular profile and do not swap between them.

Do I need it?

Only where a run changes direction or continues past a single length. A straight run in one piece does not need one.

How many should I order?

Work it out from the length of the run before you start. It is a small part, and a run waiting on one is a run that stays unfinished.

Why is there no price shown?

The Havit Commercial range is priced on application. Send an enquiry from this page with the quantity you need and we will come back with pricing.

How do I get pricing?

Send an enquiry from this page with the part number and the quantity. Pricing on this range depends on the job, so it is quoted rather than listed.

What warranty does it carry?

5 Years*