The Clovis SP is a 150mm garden spike light 24V, areplaceable 5W MR16 LED included, 400lm at2700K with CRI above 90, IP65 in black, green or corten, with aglass lens.

This is the SPIKE, not the post. Clovis is made two ways:this 150mm spike that sits in the planting, and a600mm post that stands above it. Same head, same globe, same output entirely different jobs, and no page said so.Check which you are ordering.

Low, so it uplights from within the bed

At 150mm the Clovis spike sits below the planting and throwslight up through it grazing a trunk, silhouetting foliage, washing a wall fromits base. That is a different effect from the 600mm post, which standsabove groundcover and lights down onto it. Use the spike touplight something and the post to light an area.

It needs a 24V driver, and one is not included.Ask us and we will supply it with the fitting, sized to how many you are running several share one transformer on a single low-voltage circuit. The matched unit is theC TR060.24V, and cable tail is 1,000mm.

2700K and CRI above 90 specified for planting

The combination that matters in a garden and almost nothing else offers.2700K is genuinely warm foliage looks alive rather than fluorescent.CRI>90 means greens read as greens and bark reads as bark. Most garden lightsare 3000K at CRI80 and turn a planting scheme grey-blue after dark.

The globe is replaceable and it is glass

MR16, not a sealed LED: when it fails youchange the globe, not the fitting, and you can change the beam anglelater narrow to spot a trunk, wide to wash a bed. And the lens isglass rather than polycarbonate, so it will not yellow or haze underUV. Over ten years in full Australian sun that is a real distinction.

IP65 and low voltage

Dust tight and water-jet protected, andClassIII under 54volts past the driver. In a bed that gets dug,edged and watered for years, low voltage is the right way to do it.

Where it works

• Uplighting tree trunks and shrubs from within the bed.
• Silhouetting foliage against a wall.
• Grazing a feature wall from its base.
• Full-sun positions, where glass outlasts plastic.

Specifying it

150mm tall, 60mm head, cable 1,000mm, inaluminium and glass. One MR16 LED at 5W giving 400lm at2700K INCLUDED and replaceable, CRI>90.Not dimmable.24V driver required, not included,ClassIII low voltage,IP65 dust tight and water-jet protected. Warranty is three years, as areplacement warranty.

Supplied and supported by Lights For You.

Questions

How is this different from the Clovis post light?

Same head, same globe, same output but this is a 150mm spike that sits in the planting, and the post is 600mm and stands above it. Use the spike to uplight something and the post to light an area.

Do I need anything else to run it?

Yes a 24V driver, not included. The matched unit is the C TR060.24V, and several fittings share one. Ask us and we will supply it sized to your run.

Why 2700K rather than 3000K?

It is genuinely warm and makes foliage look alive rather than fluorescent. With CRI above 90, greens read as greens most garden lights are 3000K at CRI 80 and turn a planting scheme grey-blue.

Is the globe replaceable?

Yes MR16, not a sealed LED. When it fails you change the globe, not the fitting, and you can change the beam angle later: narrow to spot a trunk, wide to wash a bed.

Why glass rather than polycarbonate?

Glass does not yellow or haze under UV. Over ten years in full Australian sun that is a real distinction a clouded plastic lens loses output and looks tired.

Does it need cover?

No. IP65 is dust tight and protected against water jets from any direction.

Is a globe included?

Yes a 5W MR16 LED giving 400lm at 2700K.