The Belmin EXS is the sensor version of the Belmin exterior wall light 285mm tall, aluminium and glass, one E27 globe, IP44 inblack or white.

We cannot tell you the sensors range. No source recordsthe detection distance, the detection angle, the time delay or the lux threshold the four figures that decide whether a sensor light suits your entry. A sensor reaching 6 metres and onereaching 12 are different products. Ask us and we will get them from Telbix before youcommit.

A sensor on a globe-fed fitting, which is unusual

Most sensor exteriors have a sealed LED: when it fails, the whole fitting comes offthe wall. The Belmin EXS takes a replaceable E27 globe, so you keep the sensor and thebody and simply re-globe it and you choose the brightness and colourtemperature yourself. That combination is genuinely rare.

40mm taller than the plain Belmin

The sensor sits in the body, so the EXS is 285mm against the standardBelmins 245mm, projecting 140mm. Both are110mm wide, so the two mix along one facade sensor at theback door, plain at the front, and they still read as a family.

Deliberately plain

No ornament a simple silhouette for a contemporary facade where the architecture isthe feature. On a security fitting that restraint is worth something: it does not announceitself as a security light.

Aluminium and glass, not plastic

More presence and weight than the polycarbonate exteriors here 1.35kg and aluminium does not rust, which outdoorsmatters more than any finish.

IP44 covered positions. Its own specification saysOutdoor (Covered Area). An eave, a porch, a covered walkway. For a fully exposed wall,ask us about the IP65 fittings.

One E27 globe to 25W, not supplied

Dimming is globe dependent our record says it does not dim, and thedatasheet says the globe decides. On a sensor fitting, though, aplain warm globe is usually the right answer.

Where it works

• Back doors and side access light on approach.
• Covered entries and porches.
• Mixed with plain Belmins along one facade.
• Ask us for the sensor range before specifying.

Specifying it

110mm wide, 285mm high, 140mm projection, 1.35kg, inaluminium and glass. One E27 globe to 25W,not supplied; dimming is globe dependent.Motion sensor fitted. 240V,ClassI earth required,IP44 covered outdoor positions. Warranty is three years, as a replacementwarranty.

Supplied and supported by Lights For You.

Questions

How far does the sensor detect?

We cannot tell you. No source records the detection distance, angle, time delay or lux threshold the four figures that decide whether it suits your entry. Ask us and we will get them from Telbix.

Why is a globe better than a sealed LED on a sensor light?

Most sensor exteriors have a sealed LED, so when it fails the whole fitting comes off the wall. This one you simply re-globe, keeping the sensor and the body and you choose the brightness and colour temperature.

How does it compare to the plain Belmin?

40mm taller 285mm against 245mm because the sensor sits in the body. Both are 110mm wide, so the two mix along one facade.

Can it go on an exposed wall?

Not on our advice. Its own specification says “Outdoor (Covered Area)” IP44 is splash protection.

What globe does it take?

One E27 up to 25W, not supplied. On a sensor fitting a plain warm globe is usually the right answer.

Can I dim it?

That depends on the globe. Our record says no; the datasheet says globe dependent, and it is right.

Will it rust?

No, it is aluminium and glass.