The Foley 80 is an 800mm LED vanity light with the LED built in a slimbar for above a bathroom mirror. Two things decide whether it suits your bathroom: its length, and itsIP rating.

IP44 is what makes it a bathroom fitting

Rated IP44, it is protected against splashing from any direction, which is what afitting above a basin needs. Australian wiring rules set zones around a bath and shower,and your electrician will confirm the fitting suits the zone you are mounting it in over avanity basin is the normal position for this one, not inside a shower enclosure.

Colour temperature is chosen at installation

It is 3CCT: a switch selects 3000K, 4000K or5000K before it goes on the wall. In a bathroom this matters more than elsewhere.3000K is flattering and warm; 4000K is usually the right answer over a mirror,because it renders skin honestly for shaving and make-up without being clinical. Set it before mounting the switch is not reachable afterwards.

Measure the mirror first

At 800mm this suits a mirror of roughly 900mm or wider, centred above it. The Foley comesin other lengths as separate products, so if your mirror is narrower or wider, check the family ratherthan forcing this one.

Where it works

• Above a vanity mirror in a bathroom or powder room, centred.
• Ensuites, where 4000K gives honest light for shaving and make-up.
• Laundries and utility rooms needing a splash-rated linear fitting.
• Mirrored dressing areas, mounted above rather than beside the glass.

Specifying it

It is 800mm long, 55mm high, projecting 100mm, in aluminium andpolycarbonate. The LED is built in and supplied 20W giving 1,155lm,with no globe to buy or replace. It is not dimmable, runs on 240V, and isClassI an earth is required. Warranty is three years.

Supplied and supported by Lights For You. Because it is non-dimmable, put it on its own switch ratherthan a shared dimmed circuit.

Questions

Can it go in a bathroom?

Yes. It is IP44 protected against splashing and is designed for above a vanity mirror. Your electrician will confirm it suits the wiring zone you are mounting it in.

Do I need to buy a globe?

No. The 20W LED is built in and supplied, giving 1,155lm. There is nothing to replace.

Which colour temperature should I choose?

4000K is usually right over a mirror it renders skin honestly for shaving and make-up. 3000K is warmer, 5000K cooler. Set it before mounting.

Is it dimmable?

No. Put it on its own switch rather than a dimmed circuit.

What size mirror does it suit?

Roughly 900mm or wider, with the 800mm fitting centred above it. Other lengths exist as separate products.

What finishes are available?

Antique gold, black or chrome.

What is the warranty?

Three years, as a replacement warranty.