The Marbell is a 250mm indoor wall light in iron and glass antique brass with amber glass, or black with smoke.

Amber glass warms the light itself

Coloured glass does not just look warm; it tints the light passing through it. Theantique brass and amber pairing produces a genuinely golden wash on the wall warmer than theglobe alone could give. Black with smoke does the opposite: it holds the light back and readsdarker.

110mm off the wall

Shallow enough for a corridor or beside a bed without catching a shoulder, on a145mm glass shade.

A full family, which is the real point

Marbell is made as wall lights, table and floor lamps, pendants and close-to-ceilingfittings. Very few Telbix ranges cover that much. If you are furnishing a whole room or a wholehouse in one language, this is one of the few that lets you.

E27 to 25W, not supplied

Behind amber glass, a plain warm globe is right the glass is doing the colour work. Behindsmoke, a clear filament globe is visible and worth the extra.

It needs an earth

ClassI hard-wired, earth required, and IP20, so nota bathroom fitting.

Where it works

• Hallways and corridors, in a run.
• Either side of a bed.
• Living rooms as accent light.
• Alongside the rest of the Marbell family.

Specifying it

250mm high, 140mm wide, 110mm projection, glass145mm, canopy 25mm, in iron and glass. OneE27 globe to 25W, not supplied. 240V,ClassI earth required,IP20 indoor and dry locations only. Warranty is three years, as a replacementwarranty.

Supplied and supported by Lights For You.

Questions

What is the difference between the two versions?

Antique brass with amber glass tints the light golden; black with smoke holds the light back and reads darker. The glass changes the light, not just the look.

Which globe should I fit?

Behind amber, a plain warm globe the glass does the colour work. Behind smoke, a clear filament globe is visible and worth the extra.

How far does it stick out?

110mm shallow enough for a corridor or beside a bed.

Can it go in a bathroom?

No. It is IP20, indoor and dry locations only.

Are there matching fittings?

Yes, and unusually many Marbell is made as wall lights, table and floor lamps, pendants and close-to-ceiling fittings.

Can I install it myself?

No. It is ClassI, hard-wired and requires an earth.

What is the warranty?

Three years, as a replacement warranty.