Welcome To our shop !

GT-504 Siena Sphere Exterior Pillar Mount

$123.995 $247.99
SKU: KO80391100860
Availability: in Stock

The Domus GT-504 Siena sphere pillar mount is a pier-top exteriorlight 170mm sphere on a 430mm high mount,300mm wide, E27, 240V,IP43, in five colours. A sphere reads the same from…

Qty:

The Domus GT-504 Siena sphere pillar mount is a pier-top exteriorlight 170mm sphere on a 430mm high mount,300mm wide, E27, 240V,IP43, in five colours.

A sphere reads the same from every direction which is the point on a pier
  • A GATE PIER IS APPROACHED FROM SEVERAL ANGLES: from the road, from the drive, from thefootpath and from inside the property.
  • A LANTERN HAS A FRONT, SIDES AND A BACK, so it is composed for one viewpoint and iscompromised from the others. A sphere has no orientation at all it presents theidentical silhouette from every approach.
  • THAT ALSO REMOVES A DECISION AT INSTALLATION. There is nowhich way should it face, and no chance of the pair on two piers being rotated differentlyfrom each other which on lanterns is a small error that is very visible once you noticeit.
  • IT IS ALSO THE MORE MODERN READING. A sphere suits rendered, masonry orcontemporary piers where a period lantern would look applied.
Pillar mounting is the cheapest exterior position on a property that has a pier
  • EVERY OTHER EXTERIOR ARRANGEMENT NEEDS SOMETHING BUILT. A post needs afooting dug and poured; a wall bracket needs a wall in the right place; a bollard needs a footing and atrench. A pillar mount needs a pier that is already there.
  • WHAT IT STILL NEEDS IS A CABLE ROUTE. Getting a supply to the top of asolid masonry pier is straightforward if a conduit was built in and a real problem if it wasnot. Check before specifying surface conduit up a pier isconspicuous.
  • AND CHECK THE PIER TOP. The mount is 300mm wide, sothe pier top must be larger than that and flat. A brick-and-a-half pier at about350mm suits it; a single-brick pier at 230mm does not. A capped pier with a moulded or pitched top needs the cap worked or a spreader plate, which ismasonry work rather than electrical.
  • PROPORTION MATTERS AS MUCH AS FIT. A 430mm mount on a 1.2mpier adds a third again to its height, which reads as generous; on a 2m pier it looksmodest.
IP43 on the most exposed position in the range
  • IP4X keeps out objects over 1mm wires and mostinsects. IPX3 covers spraying water to 60 from vertical. Not drivingrain, hosing or sprinklers.
  • A PIER TOP IS THE MOST EXPOSED POSITION ANY OF THESE ARRANGEMENTS OCCUPIES. No eave, no wall, nothing around it to break the wind so wind-driven rain reaches it fromevery direction and the fitting’s own body is its only shelter.
  • THE SPHERE HELPS HERE TOO: a curved surface sheds water in every direction rather thanholding it in a horizontal seam, which is where a lantern usually lets waterin.
  • SEAL THE BASE TO THE PIER PROPERLY AT INSTALLATION. Water sitting betweenthe fitting and the masonry is what corrodes the fixing, and it is the point nobodyinspects.
E27, no lamp, and opal is the only sensible choice

The lamp is not included. IN A SPHERE THE LAMP IS VISIBLE FROM EVERYANGLE AND THERE IS NOWHERE FOR IT TO HIDE, so a clear or filament lamp is a bright point at theentrance glary from a car, from the footpath and from neighbouringproperties. An opal E27 fills the sphere and turns it into a single glowing object,which is the entire effect this fitting exists for. A globe-shaped lamp sized to fill the170mm sphere works better than a compact one sitting low, which lights the bottom half and leavesthe top dim. Warm rather than cool: at an entrance, cool white reads asinstitutional.

In pairs, almost always

Gate piers come in pairs, and so should the spheres. THAT MEANS TWOLAMPS THAT MUST MATCH: bought from one batch and replaced together, because the two piers are seen side byside and a difference in colour or brightness between them is unmissable. It also means two cable routes, which is worth confirming before specifying rather thanafter. The sheet names related references GT-502 and GT-503 wall brackets, andthe GT-544/545 so the Siena shape can carry across a property.

Made to order

Allow up to 10 business days for production. Published, which is unusual inthis catalogue five colours in a made-to-order range means the finish is applied to yourorder.

What is published
Specification Value
A sphere has no orientation Identical from every approach
Which removes an install decision No pair rotated differently from each other
Why choose a pillar mount The only arrangement needing nothing built
What it still needs A cable route up the pier
Pier top must be Flat and larger than 300mm not a single brick
Dimensions 170mm sphere 430mm high 300mm wide
Exposure The most exposed position in the range
But the sphere sheds water No horizontal seam to hold it
Lamp base / IP E27, not included use opal IP43
Lead time / warranty Up to 10 business days 1 year
Where it works
  • Masonry gate piers nothing to build.
  • Rendered and contemporary piers where a lantern looks applied.
  • Approached from several angles no front or back.
  • Not on a single-brick pier 300mm needs 350.
  • Not without a cable route surface conduit is conspicuous.
Specifying it

Pier-top exterior sphere light. 170mm sphere, 430mm high, 300mm wide. E27,lamp not included. 220240V. IP43. Aluminium. Five colours. Made to order, up to 10 business days.1-year warranty. A SPHERE READS THE SAME FROM EVERY DIRECTION, WHICH IS THE POINT ON A PIER: a gate pier isapproached from the road, the drive, the footpath and from inside the property, and a lantern has a front,sides and a back so it is composed for one viewpoint and compromised from the others. It also removes adecision at installation no “which way should it face”, and no chance of the pair on two piers beingrotated differently from each other. AND PILLAR MOUNTING IS THE CHEAPEST EXTERIOR POSITION ON APROPERTY THAT ALREADY HAS PIERS, because every other arrangement needs something built. WHAT IT STILLNEEDS IS A CABLE ROUTE.

Supplied and supported by Lights For You.

Questions

Why a sphere rather than a lantern?

Because a pier is approached from several angles from the road, the drive, the footpath and from inside the property. A lantern has a front, sides and a back, so it is composed for one viewpoint and compromised from the others; a sphere has no orientation at all and presents the identical silhouette from every approach.

Does that help at installation?

It removes a decision. There is no “which way should it face”, and no chance of the pair on two piers being rotated differently from each other which on lanterns is a small error that is very visible once you notice it. A sphere also suits rendered, masonry or contemporary piers where a period lantern would look applied.

Why is a pillar mount economical?

Because it needs nothing built. Every other exterior arrangement does a post needs a footing dug and poured, a wall bracket needs a wall in the right place, a bollard needs a footing and a trench. A pillar mount needs a pier that is already there.

What does it still need?

A cable route. Getting a supply to the top of a solid masonry pier is straightforward if a conduit was built in and a real problem if it was not surface conduit up a pier is conspicuous. Check before specifying rather than after.

Will it fit my pier?

The mount is 300mm wide, so the pier top must be larger than that and flat. A brick-and-a-half pier at about 350mm suits it; a single-brick pier at 230mm does not. A capped pier with a moulded or pitched top needs the cap worked or a spreader plate, which is masonry work rather than electrical. Proportion matters too: a 430mm mount adds a third again to a 1.2m pier, which reads as generous, where on a 2m pier it looks modest.

How exposed is a pier top?

The most exposed position any of these arrangements occupies no eave, no wall, nothing around it to break the wind, so wind-driven rain reaches it from every direction. The sphere helps here too: a curved surface sheds water in every direction rather than holding it in a horizontal seam, which is where a lantern usually lets water in. Seal the base to the pier properly at installation, because water sitting between the fitting and the masonry is what corrodes the fixing.

What lamp should I use?

An opal E27, and here it is not really optional. In a sphere the lamp is visible from every angle and there is nowhere for it to hide, so a clear or filament lamp is a bright point at the entrance glary from a car, the footpath and neighbouring properties. An opal lamp fills the sphere and turns it into a single glowing object, which is the entire effect this fitting exists for. Use a globe-shaped lamp sized to fill the 170mm sphere; a compact one sitting low lights the bottom half and leaves the top dim.

Only logged in customers who have purchased this product may leave a review.

Shipping policy for our store

We offer fast and reliable shipping worldwide. All orders are carefully packaged and shipped within 1–3 business days after payment confirmation.

  • Fast shipping within 1-3 business days
  • Free shipping on orders over $40
  • 30 days money back guarantee
  • 24/7 online customer support
  • Secure packaging & safe delivery

Standard shipping, expedited shipping and express delivery options are available at checkout. Delivery time depends on your destination country and local logistics.