The Domus NEO-PRO SM is a surface-mounted LED downlight in black or white 13W, 25W or 35W, 75 beam,switchable 3000K / 4000K / 5700K, andIP65 from the front.

The IP65 applies to the front only. The datasheetqualifies it and our page carried the bare number.

That means the face is sealed against dust and water jets, and theback and the mounting surface are not. In practice:

• Fine on a covered soffit, an alfresco ceiling or a bathroom ceiling, wherewater can only arrive from below and in front.
• Not for a position where water can reach behind it an exposed soffitedge, a wall where water runs down, or anywhere it is hosed from above.

Ask us if the position is exposed, and let your electrician site it toAS/NZS3000.

Surface mounted no hole in the ceiling

This is the reason to choose it over every recessed downlight in this catalogue:

• Concrete ceilings. You cannot recess into a slab without coring. A surface-mountedfitting screws to it.
• No ceiling void apartments, second storeys with shallow battens, renderedsoffits.
• Insulation stays intact. Nothing is cut, so nothing has to be cleared around it.
• Fire and acoustic ceilings stay unbroken, which in a rated ceiling is not a smallthing.
• The trade: it projects 107mm below the ceiling and it isvisible. That is a design decision, not a compromise a row of them reads asdeliberate.

Three wattages, one listing

13W, 25W and 35W, all 90mm and 107mm deep. The13W gives 1,000 / 1,200 / 1,100lm at 3000 / 4000 / 5700K.

Only the 13W figures are recorded. For the 25W and 35W output,ask us we will not scale a lumen figure by arithmetic, because efficacy doesnot hold constant across a range.

• 13W general room lighting, about 1.5m apart.
• 25W higher ceilings, or fewer fittings.
• 35W commercial, retail, high bays and stairwells.

The 75 beam

Wide between the DECO’s 90 wash and the SCOOP’s 60 accent. That makes it ageneral room light rather than a spot, and it suits the surface-mount format: aprojecting fitting throwing a narrow beam draws attention to itself.

SMD, CRI 80,50,000hours, 90mm, 107mm deep.Fully dimmable with a suitable dimmer tell us which one.

No warranty is recorded for this product. Ask us before you quote; we willnot state a term we do not hold.

The colour is set before installation and the top setting is5700K colder than the 5000K many people expect.

Where it works

• Concrete ceilings and slabs nothing to core.
• Apartments and shallow voids where recessing is impossible.
• Fire-rated and acoustic ceilings that must stay unbroken.
• Covered soffits and alfresco ceilings IP65 from the front.
• Not where water can reach behind it.

Specifying it

90mm, 107mm deep, surface mounted, black or white.13W / 25W / 35W; the 13W gives1,000 / 1,200 / 1,100lm at3000K / 4000K / 5700K switchable, set before installation.SMD, CRI 80, 75 beam,50,000hrs, dimmable with a suitable dimmer.220240V AC, IP65 FROM THE FRONT ONLY. 25W and 35W outputs, and the warranty, are not recorded askus.

Supplied and supported by Lights For You.

Questions

What does “IP65 from front only” mean?

The face is sealed against dust and water jets and the back and mounting surface are not. It is fine on a covered soffit, an alfresco ceiling or a bathroom ceiling where water can only arrive from below and in front. It is not for a position where water can reach behind it an exposed soffit edge, a wall where water runs down, or anywhere hosed from above. Our page carried the bare IP65 without the qualifier.

Why choose surface mounted over recessed?

Because sometimes you cannot recess. A concrete slab needs coring; an apartment or a shallow batten space has no void; a fire-rated or acoustic ceiling should stay unbroken; and insulation stays intact when nothing is cut. The trade is that it projects 107mm below the ceiling and is visible which a row of them turns into a deliberate look rather than a compromise.

How bright are the 25W and 35W?

Not recorded, and we will not scale the 13W figure by arithmetic because efficacy does not hold constant across a range. The 13W gives 1,000 to 1,200 lumens depending on colour setting. Ask us for the larger two and we will get them from Domus.

Which wattage should I choose?

13W for general room lighting at about 1.5m spacing; 25W for higher ceilings or fewer fittings; 35W for commercial, retail, high bays and stairwells. All three are the same 90mm body.

Is the top setting 5000K?

No 5700K, which is colder and bluer. It is set before installation and cannot be changed afterwards.

Can I dim it?

Yes, with a suitable dimmer. Tell us which one you plan to use LED dimming compatibility is much easier to settle before installation than after.

What is the warranty?

Not recorded for this product. Others in this catalogue run from one to five years, and we would rather tell you we do not hold the figure than guess. Ask us and we will confirm with Domus.