Welcome To our shop !

Split 316 Stainless Steel TRI Colour 3w – 12V DC

$68 $136
SKU: KO80391101171
Availability: in Stock

The Split is a 3 W recessed inground uplighter in 316 stainless steel, and thislisting sells the 12 V DC part, HV1841T. It sits flush in a canisterbelow ground level…

Qty:

The Split is a 3 W recessed inground uplighter in 316 stainless steel, and thislisting sells the 12 V DC part, HV1841T. It sits flush in a canisterbelow ground level with a clear tempered-glass face and an anti-glare honeycomb louvre, and it istrafficable to 1000 kg, so it can be driven over in a path or a driveway.

Low voltage, and it needs its own driver

This part runs on 12 V DC constant voltage and an external supply is required: youmust run it from a suitable 12 V DC constant-voltage LED driver. It isProtection Class III, so no earth is required at the fitting. It must not be connected directly to 240 V. It is alsopolarity sensitive Havit’s installation sheet says that if it is connected the wrongway round the fitting will fail and the warranty is void. Supply at the fitting has to stay within5% of the rated voltage; outside that allowance the warranty is void as well. Wiringis parallel, and the whole job is one for a qualified electrician working toAS/NZS 3000.

Tri-colour, switched on the underside before it goes in the ground

The built-in LED is tri-colour: 3000K, 4000K and5500K, giving 220 lm, 230 lm and240 lm respectively, through a 60 beam at CRI >80. The selector is a switch on the bottom of the fitting, inside a sealed brass cover.On a recessed fitting that means choose the colour temperature before you drop it into thecanister changing it later means lifting the fitting back out and re-sealing it. There is noglobe and no socket here, so nothing is ever replaced; lamp expectancy is >30,000hrs.The fitting is not dimmable, which both of Havit’s documents state.

IP67, IK10, and the conditions that carry the warranty

It is IP67 and IK10 behind a clear glass diffuser. Adequate drainage under the canister is a warranty condition, not arecommendation Havit asks for 100150 mm of crushed rock and a slight fall so water runs away, andsays plainly that if no drainage is allowed the warranty is void. Theanti-syphon plug and the male and female connector supplied on thecable must both stay on it. All o-rings and seals must be seated, every joint solderedand sealed watertight, and silicone applied around the edge of the fitting. 316 stainless still needs regular cleaning to stop tea staining forming, andtea staining is not covered by the warranty. Lights For You has taken every figure onthis page for HV1841T from the HV1841 data sheet (AUG24), theHV1841T / HV1841RGBW installation instructions and Havit’s own page for this model,which states a 3 Years Replacement Warranty.

Questions

Can it be wired without a driver?

No. This part is 12 V DC and must not be connected directly to 240 V. It needs a suitable 12 V DC constant-voltage LED driver sized for the run. Havit sells a separate part number for installations that take no driver, and it is a different listing to this one.

Does it matter which way round I connect it?

Yes. It is polarity sensitive. Havit’s installation sheet states that if the fitting is connected incorrectly it will fail and the warranty will be void, so match positive to positive and neutral to neutral before you solder anything.

How do I set the colour temperature?

A switch on the bottom of the fitting, inside a sealed brass cover. Set it to 3000K, 4000K or 5500K and re-seat the cover tightly. Do this before the fitting goes into the canister afterwards the switch is under the light and under the ground.

Can I drive over it?

Yes. Havit rates the Split at 1000 kg trafficable and it is IK10, the top of the impact scale. It still needs the canister set level with the finished surface, which is itself a warranty condition.

What drainage does it need?

100150 mm of crushed rock under the canister and a slight fall on the surrounding ground so water runs away from the fitting. Havit is explicit that if no drainage is allowed the warranty is void it is the single most common way an inground light fails.

Can it be dimmed?

No. Both of Havit’s documents record this model as not dimmable, so plan a switched circuit rather than a dimmed one. The RGBW version of the Split is the one with variable output, and it is controlled by an RGBW controller rather than a dimmer.

Does the 316 stainless need looking after?

Yes. Havit requires regular cleaning maintenance on all 316 stainless fittings to stop tea staining forming, and states that tea staining is not covered by the warranty. A rinse and a wipe when you clean the path is usually enough.

Only logged in customers who have purchased this product may leave a review.

Shipping policy for our store

We offer fast and reliable shipping worldwide. All orders are carefully packaged and shipped within 1–3 business days after payment confirmation.

  • Fast shipping within 1-3 business days
  • Free shipping on orders over $40
  • 30 days money back guarantee
  • 24/7 online customer support
  • Secure packaging & safe delivery

Standard shipping, expedited shipping and express delivery options are available at checkout. Delivery time depends on your destination country and local logistics.