Welcome To our shop !

Split 316 Stainless Steel 3w RGBW LED

$79.995 $159.99
SKU: KO80391101313
Availability: in Stock

The Split RGBW is the colour-change version of the same 3 W inground uplighter, partnumber HV1841RGBW, in 316 stainless steel with a clear tempered-glass face and ananti-glare honeycomb louvre. It…

Qty:

The Split RGBW is the colour-change version of the same 3 W inground uplighter, partnumber HV1841RGBW, in 316 stainless steel with a clear tempered-glass face and ananti-glare honeycomb louvre. It recesses into a canister below ground level and istrafficable to 1000 kg. Where the tri-colour Split gives you three fixed whitesettings, this one gives full RGB colour plus a 3000K warm white channel.

It needs two things, not one

This part runs on 12 V DC constant voltage, so it needs a suitable12 V DC LED driver and it also needs an RGBW controller between thedriver and the fitting. Havit’s wiring order is driver, then controller, then fitting. Without thecontroller there is no way to select or change a colour at all. It isProtection Class III, so no earth is required at the fitting. It must not be connected directly to 240 V. Supply at the fitting has to stay within5% of the rated voltage or the warranty is void, and wiring isparallel. The cores are colour-coded and Havit asks you to check the label on the cableand match each one before soldering. Installation is work for a qualified electrician workingto AS/NZS 3000.

Output, and the accessory that is the wrong one

Havit’s ordering table gives this fitting 155 lm measured on its3000K channel, from a 3 W built-in RGBW LED atCRI >80, with a lamp expectancy of >30,000hrs. It isdimmable only through the RGBW controller. A wall dimmer is the wrong accessory forthis fitting Havit records its dimming as yes, with RGBW controller and lists no wall dimmeragainst it. There is no globe and no socket, so nothing is ever replaced.

IP67, IK10, and the conditions that carry the warranty

It is IP67 and IK10 behind a clear glass diffuser. Adequate drainage under the canister is a warranty condition, not advice Havitasks for 100150 mm of crushed rock and a slight fall so water runs away from the fitting, and statesthat if no drainage is allowed the warranty is void. The anti-syphon plug and themale and female connector supplied on the cable must both stay on it. Allo-rings and seals must be seated, every joint soldered and sealed watertight, andsilicone applied around the edge of the fitting once it is seated. 316 stainless needs regular cleaning to stop tea staining forming, andtea staining is not covered by the warranty. The figures on this page for HV1841RGBWwere read by Lights For You from the HV1841 data sheet (AUG24), theHV1841T / HV1841RGBW installation instructions, and Havit’s own page for this partnumber, which states a 3 Years Replacement Warranty.

Questions

What do I need to run it besides the light?

Two things: a suitable 12 V DC LED driver and an RGBW controller. Havit’s wiring order is driver, then controller, then fitting. The controller is not optional without it there is no way to select a colour.

Can I put it on a normal wall dimmer?

No, and it is worth being clear about why: Havit records this fitting’s dimming as yes, with RGBW controller, and lists no wall dimmer against it at all. Brightness and colour are both handled by the controller, so a dimmer on the supply side is the wrong accessory rather than simply an ineffective one.

Can it be wired without a driver?

No. It is 12 V DC and must not be connected directly to 240 V. It is Protection Class III, so no earth is required at the fitting itself, and the supply has to stay within 5% of the rated voltage or the warranty is void.

How bright is it?

Havit publishes 155 lm for this fitting, measured on its 3000K channel. Colour channels on any RGBW fitting read lower than white, so treat that figure as the white output rather than the output of a saturated colour.

How is it different from the tri-colour Split?

The tri-colour version gives three fixed whites 3000K, 4000K and 5500K chosen on a switch under the fitting, and it is not dimmable. This one gives full RGB colour plus a 3000K white and is changed at any time from the controller. Same body, same 316 stainless, same 3 W and the same canister.

Can I drive over it?

Yes. It is rated 1000 kg trafficable and IK10, the top of the impact scale. The canister still needs to be set level with the finished surface, which Havit makes a warranty condition.

Does the 316 stainless need looking after?

Yes. Havit requires regular cleaning maintenance on all 316 stainless fittings to avoid tea staining forming, and states that tea staining is not covered by the warranty.

Only logged in customers who have purchased this product may leave a review.

Shipping policy for our store

We offer fast and reliable shipping worldwide. All orders are carefully packaged and shipped within 1–3 business days after payment confirmation.

  • Fast shipping within 1-3 business days
  • Free shipping on orders over $40
  • 30 days money back guarantee
  • 24/7 online customer support
  • Secure packaging & safe delivery

Standard shipping, expedited shipping and express delivery options are available at checkout. Delivery time depends on your destination country and local logistics.