Welcome To our shop !

Maxi 600 316 Stainless Steel TRI Colour LED

$130.5 $261
SKU: KO80391101496
Availability: in Stock

One fitting, two part numbers, and the choice between them is bigger than the voltagelabel. The Maxi 600 in natural 316 stainless is sold as a 240 V AC model…

Qty:

One fitting, two part numbers, and the choice between them is bigger than the voltagelabel. The Maxi 600 in natural 316 stainless is sold as a 240 V AC model and a 12 V DC model,and they differ in brightness, in protection class, in what your electrician has to run and in how farthe fitting can sit from its supply. Worth ten minutes before you order a run of them.

The 240 V model: brighter, earthed, no driver

It takes a 9 W E27 tri-colour globe and produces 700 lm at 3000K, 720 lm at4000K and 740 lm at 5500K. It is Class I, so it wires to the circuit with anearth conductor and needs no driver at all. If the bollards are going in as part of a mainsinstallation a new path, a driveway edge, anywhere a cable is already being run this is the simplerof the two and roughly two and a half times the light.

The 12 V model: safer to work near, but it has rules

It takes a 5 W MR16 globe for 270 lm, 285 lm and 300 lm, and it isClass III no earth required, because a suitable 12 V DC LED driverprovides the isolation. Never connect it directly to 240 V. Two constraints come with it:no more than 25 m from the driver, with the supply within 5%, which Havit states is awarranty condition rather than guidance, and a 15 W maximum on any replacement globe,LED only. Havit’s HV9507 tri-colour MR16 is the listed 12 V DC alternative, and at60 against the supplied globe’s 120 it is a useful reminder that thebeam belongs to the globe rather than to the fitting.

What applies whichever you choose
  • 600 mm tall, 102 mm, on a 98 mm base plate with four fixingholes. That plate must be on concrete or a concrete pad, above ground level, with all holes siliconed a warranty condition.
  • IP54 splash protection, IK08 impact, CRI >80,>30,000 hrs lamp expectancy, parallel wiring, and not dimmable with the globessupplied.
  • Bare 316 stainless asks for maintenance every six months, more frequently in coastalenvironments, using Havit’s HV9971 kit and tea staining is not covered by thewarranty.
  • 3 Years Replacement warranty, with the HV1607 spike available ifa concrete footing is not practical.

Send Lights For You the site plan and we will tell you which supply makes the job simpler.

Questions

Which version should I buy?

The 240 V model if a mains cable is already going in it is brighter, needs no driver and simply wires to the circuit with an earth. The 12 V model if you are extending an existing low-voltage garden run or want the lower-risk cable in a bed people dig in. Both are the same fitting and the same finish.

What is the difference in brightness?

Substantial. The 240 V model gives 700, 720 and 740 lumens from its 9 W E27 globe; the 12 V model gives 270, 285 and 300 from its 5 W MR16. That is roughly two and a half times, so do not treat the two part numbers as interchangeable on a mixed run.

Does the 12 V version need an earth?

No. It is Class III, so the isolation comes from the 12 V DC LED driver rather than from an earth conductor. The 240 V version is Class I and does need one. That difference is on Havits data sheet and is one of the real reasons to choose one over the other.

How far can the fitting be from the driver?

No more than 25 metres, with the voltage at the fitting within 5% of what it needs. Havit states plainly that outside this allowance the warranty is void, so the driver position has to be planned before the cable run, not after.

Can I put a brighter globe in it?

Up to 15 watts, LED only that is Havits stated ceiling for this fitting. Its own HV9507 tri-colour MR16 is offered up to 7 W for the 12 V model, and it has a 60 beam against the supplied globes 120, which will noticeably tighten the pool of light.

How much looking after does the bare stainless need?

A clean every six months, and more often in coastal environments, using Havits HV9971 maintenance kit. It is not optional in warranty terms: tea staining is specifically excluded from cover, and it is the thing regular cleaning prevents.

Is IP54 enough for an exposed path?

For rain, sprinklers and a passing hose, yes. It is not rated for jets or for standing water, which is why the base plate has to be on concrete above ground level with the cable entry sealed. Avoid any position that holds water after heavy rain.

Only logged in customers who have purchased this product may leave a review.

Shipping policy for our store

We offer fast and reliable shipping worldwide. All orders are carefully packaged and shipped within 1–3 business days after payment confirmation.

  • Fast shipping within 1-3 business days
  • Free shipping on orders over $40
  • 30 days money back guarantee
  • 24/7 online customer support
  • Secure packaging & safe delivery

Standard shipping, expedited shipping and express delivery options are available at checkout. Delivery time depends on your destination country and local logistics.