This is the fixed-down Tivah in 316 marine-grade stainless steel: the beam points down and does not adjust, which is exactly what you want on a pillar cap or a boundary wall where an aimable head would eventually get knocked out of alignment or throw glare across a fence. 316 is the stainless grade specified for salt exposure, and the IP65 rating means the fitting takes direct rain rather than needing an eave over it. The important call at the cart is the part number, because the three codes split across two voltages.

The choice to make

HV1105T and HV1107GU10T are 240V GU10 fittings and wire straight to mains no driver. HV1107MR16T is 12V DC with an MR16 lamp and requires a 12V DC LED driver; it must never be connected directly to 240V power. Outputs follow the platform: HV1105T runs 200560lm at 3000K, 255595lm at 4000K and 270630lm at 5500K depending on the 3/5/7W GU10 fitted; HV1107GU10T and HV1107MR16T both give 270lm at 3000K, 285lm at 4000K and 300lm at 5500K on 5W lamps. Beam choices are 60 and 120.

Where it works

• Driveway and gateway pillars, throwing a controlled pool onto the paving below.
• Coastal and beachside frontages where 316 stainless is the correct specification.
• Boundary and retaining walls, lighting the ground without spilling over the fence line.
• Exposed alfresco walls and pool surrounds that see direct rain and hosing.

Specifying it

The 12V MR16 variant must be installed no more than 25m from its driver. That is a warranty limit past 25m the voltage drop over the cable run reduces output and shortens lamp life. The lamp is replaceable on all three variants and the base must match the code you bought; GU10 and MR16 lamps do not interchange. The GU10 socket accepts a maximum of 35W. The GU10 versions require an earth. It is not dimmable with the supplied globes.

Supplied and supported by Lights For You; this is the fixed-down Tivah, so if you need to aim the beam up a wall as well, order the adjustable HV1305T/HV1307T version instead and check whether your run is 240V or 12V before ordering either.

Questions

Do I need a driver for this light?

Only for HV1107MR16T, which is 12V DC and needs a 12V DC LED driver. HV1105T and HV1107GU10T are 240V and connect straight to mains.

Can the 12V variant be wired to 240V?

No. Never connect it directly to 240V power it will be destroyed and the installation is unsafe.

What is the maximum distance from the driver?

25m for the 12V variant. Exceeding it causes voltage drop and voids the warranty.

Is it suitable for a coastal property?

Yes. It is 316 marine-grade stainless steel rated IP65 for direct rain and salt-air exposure.

Can the head be adjusted?

No. This is the fixed-down model. For an aimable head, choose the adjustable Tivah instead.

Is the globe replaceable, and what base is it?

Yes. GU10 on the GU10 part numbers and MR16 on the MR16 part number; the two bases do not interchange.

What is the maximum globe wattage?

35W for the GU10 socket. It is a heat limit exceeding it is a fire risk and voids the warranty.

Is it dimmable?

Not with the supplied globes.

What warranty applies?

A 3-year replacement warranty.