8W E27 LED globe

A replacement LED globe on the standard large screw base, running on 240V. E27 is the common large screw base – the one most people picture as a light globe. It runs on mains and screws in.

Globes are the one part of a light fitting that is genuinely consumable, and the reason to buy a good one is that a fitting outlives many of them. Getting the base right is the whole job – everything else is a preference.

Light output

It draws 8W and is rated at 800lm, 805lm and 810lm. Colour rendering is > 80.

It is a tri-colour globe: the colour temperature is selected on the globe itself – 2700K, 4000K and 5500K – rather than being fixed when it was made. That is genuinely useful in a replacement globe, because one part number covers a warm bedroom and a neutral kitchen.

Dimming

This globe is dimmable. On a lamped fitting the DIMMING BEHAVIOUR FOLLOWS THE GLOBE, not the fitting – so a dimmable globe is what makes a dimmed circuit work, and a non-dimmable one will buzz, flicker or refuse to dim no matter what the fitting claims. The dimmer itself should be one rated for LED loads.

Getting a long life out of it

An LED globe rarely fails the way a halogen did. What kills it early is heat: the electronics sit in the base, and in a sealed or insulated fitting that heat has nowhere to go. A globe that dies within months in one fitting and lasts for years in another is almost always telling you about the fitting, not the globe.

If a fitting is fully enclosed, check it is rated for that before assuming the globe is at fault. The same applies to insulation packed against a downlight in a ceiling – it traps heat around the very part that is least tolerant of it.

Before you order

This globe runs on mains, so it needs no transformer or driver behind it. Check the base on the globe you are replacing rather than the shape of the fitting – mains and low-voltage fittings look very similar from below, and the bases are not interchangeable.

Take the old globe with you or photograph its markings. Our team at Lights For You can identify a base from a clear photograph, which is faster than measuring pin spacing.

Frequently asked questions

What base is it?

E27 – the standard large screw base.

Does it need a transformer or driver?

No. It runs directly on mains.

Can it be dimmed?

Yes, on a dimmer rated for LED loads.

How do I set the colour temperature?

It is selected on the globe itself, so decide before fitting it – especially if several are going into one room.

How do I check I am ordering the right one?

Photograph the markings on the old globe and send them to us – the base is the part that must match exactly.