The Prime tilt is a 12W recessed downlight that aims the lamp assembly tilts about20 inside a fixed 90mm bezel, so the trim stays square to the ceiling while the light pointswhere you want it. That is the whole reason to choose it over a fixed downlight: you can wash a wall,graze a splashback or light a picture without a visible gimbal breaking the ceiling line.

Tilt is for aiming, not for coverage

A tilting downlight is specified where the target is not directly below the hole. Angled along akitchen run it lights the bench face rather than the front edge of the cabinets; turned toward a featurewall it grazes the surface. Set the aim during commissioning once the ceiling is patched andpainted, adjusting means getting back into it.

Where it works

• Kitchen runs, angled at the bench and splashback instead of the cupboard fronts.
• Feature and art walls, grazing the surface rather than lighting the floor in front of it.
• Hallways with a long sightline, aimed slightly along the corridor to avoid a row of hot spots.
• Wardrobe and pantry interiors, angled into the shelving.

Specifying it

It takes a 90mm cut-out and the LED is built in no globe, no socket.Output is 980lm, 990lm and 1,000lm across the three tri-colour settings of3000K, 4000K and 5500K, on a 45 beam. CRI is 90 or better, whichis the specification that matters in a kitchen or anywhere colour is judged food, fabric andtimber all read wrong under a low-CRI lamp. It is dimmable and is supplied with adimmable LED driver complete with flex and plug, runs on 240V AC, and is IP54 with an IC-4 rating onthe fitting itself. Matt black or white.

Supplied and supported by Lights For You. Because it arrives with its own dimmable driver on a flexand plug, it drops into an existing 90mm hole without rewiring useful on a retrofit where theold fitting was the same cut-out.

Coastal siting Havits condition

Havits installation instructions for this fitting state that aluminium and 304 stainless steel fittings must not be installed within 5 km of any salt water environment. That is a condition on where the fitting may go, and it sits beside the IP rating rather than inside it: a fitting can be rated for direct rain and still fall outside this rule, because the issue is salt carried in the air rather than water landing on the surface. If your site is inside that zone, talk to us before you specify it Lights For You can point you at a fitting whose material Havit does not name here.

Earthing and protection class

This fitting runs on 240 V AC mains and is Protection Class 2 it is double insulated, so no earth is required at the fitting.

Questions

How much does it tilt?

About 20 inside a fixed bezel, so the trim stays square to the ceiling while the beam aims off-centre.

What cut-out does it need?

90mm.

Is it dimmable?

Yes. It is supplied with a dimmable LED driver complete with flex and plug.

What is the CRI?

90 or better worth specifying anywhere colour is judged, such as a kitchen bench or a wardrobe.

Is there a globe to replace?

No. The 12W LED is built in, with no socket and no replaceable lamp.

How bright is it?

980lm, 990lm and 1,000lm across the three colour-temperature settings, on a 45 beam.

What is the warranty?

Three years, as a replacement warranty.