Welcome To our shop !

Cadrado Black Aluminium Bollard – 600mm

$149 $366.99
SKU: KO80391096540
Availability: in Stock

The Cadrado is a 600 mm surface-mounted bollard with a sealed built-in LED, in polypowder-coated black aluminium behind a glass diffuser. There is no lamp holder and no globe to…

Qty:

The Cadrado is a 600 mm surface-mounted bollard with a sealed built-in LED, in polypowder-coated black aluminium behind a glass diffuser. There is no lamp holder and no globe to buy: the10 W tri-colour engine is part of the fitting, and the only thing you choose after installation is thecolour temperature.

240 V AC mains, earthed, and wired by an electrician

It runs on 240 V AC mains. It is Protection Class 1 andrequires an earth, and Havit’s installation sheet opens by requiring aqualified electrician working to AS/NZS 3000. There is no transformer and no driver inthis product, and where several run from one circuit they are wired in parallel.

The colour switch is under the head, and it slides

It leaves the factory set to 3000K. To change it you remove the cover from asliding switch on the underside of the head, choose 3000K,4000K or 5500K, and refit the cover carefully so water cannot get in.That is a one-time decision made with the fitting in your hands, not a setting you can reach laterwithout opening it again.

Output does not climb with colour temperature

Havit pairs the figures as 700 lm at 3000K, 750 lm at 4000K and725 lm at 5500K. 4000K is the brightest of the three the numbers donot rise as the light gets cooler, so do not read the list as a ladder. The spread is120, colour rendering is CRI >80, and lamp expectancy is>30,000hrs.

It is dimmable, which most of this range is not

Both of Havit’s documents record it as Triac dimmable, and its own data sheet namesthe HV9625 Triac Dimmer as the compatible accessory. That is unusual here mostbollards in this range are switched only so it is worth designing the circuit around before thetrenching goes in.

IP65 and IK08, and one restriction on where it can go

The body is IP65 and IK08, a genuinely useful impact class on theIK01IK10 scale, which matters on something at shin height beside a mower. Havitstates that aluminium and 304SS fittings must not be installed within 5 km of any salt waterenvironments. This bollard is aluminium, so that applies to it directly and it is a warrantycondition, not a suggestion.

Installation, and the siliconing that carries the warranty

It is surface mounted: the base plate fixes to concrete or a concretepad, and the fitting must not be installed under ground level. Havit asksfor silicone twice all holes including the cable entry must be filled, and siliconemust also be applied around the fitting at ground level and failure to do eithervoids the warranty. All o-rings and seals must be in place, and if your cable isnot circular you must fix the cable entry to maintain the IP rating. Lights For You hastaken every figure on this page for HV1636T-BLK-240V from the HV1636T-BLK data sheet,the HV1636T installation instructions and Havit’s own page for this model, which statesa 3 Years Replacement Warranty.

Questions

Is this a low-voltage bollard?

No. It is 240 V AC mains, Protection Class 1, and it must be earthed and installed by a qualified electrician working to AS/NZS 3000. There is no transformer or driver in this product at all.

Is there a globe to replace?

No. The 10 W tri-colour engine is a built-in LED there is no lamp holder, no socket and nothing to unscrew, so there is no replacement lamp to buy and no maximum globe wattage to work to.

How do I change the colour temperature?

Take the cover off the sliding switch on the underside of the head, select 3000K, 4000K or 5500K, and refit the cover so it seats properly against water. It arrives set to 3000K.

Which setting is the brightest?

4000K, at 750 lm. The other two are 700 lm at 3000K and 725 lm at 5500K. Output does not rise with colour temperature here, so the middle setting is the bright one.

Can it be dimmed?

Yes it is Triac dimmable on both of Havit’s documents for this model, and the data sheet names the HV9625 Triac Dimmer as the compatible accessory. Specify the dimmer with the circuit rather than after it.

Can I install it near the beach?

No. Havit states that aluminium and 304SS fittings must not be installed within 5 km of any salt water environments, and this bollard is aluminium. That is a warranty condition, so a coastal site needs a fitting rated for it instead.

Does the head move?

No. The head is fixed and the beam is a 120 wash. If you need to point the light somewhere specific, that is a different model in the range this one is not adjustable.

Only logged in customers who have purchased this product may leave a review.

Shipping policy for our store

We offer fast and reliable shipping worldwide. All orders are carefully packaged and shipped within 1–3 business days after payment confirmation.

  • Fast shipping within 1-3 business days
  • Free shipping on orders over $40
  • 30 days money back guarantee
  • 24/7 online customer support
  • Secure packaging & safe delivery

Standard shipping, expedited shipping and express delivery options are available at checkout. Delivery time depends on your destination country and local logistics.