Welcome To our shop !

Domus SHADOW 1LT W/B 240V GU10 TRIO

$57.5 $115
SKU: KO80391095923
Availability: in Stock

The Domus SHADOW 1LT W/B is a downward exterior wall light 240V GU10, IP65, in bronze orbrass. Its sheet names GU10 only and here that is correct The one-light sheets…

Qty:

The Domus SHADOW 1LT W/B is a downward exterior wall light 240V GU10, IP65, in bronze orbrass.

Its sheet names GU10 only and here that is correct
  • The one-light sheets in this family name GU10 and never MR16, which is a stale revision:they were not updated when Domus added the 12V option. Measured, the two-lightsheets name both lamps 3 of 3 and the one-light sheets 0 of 3.
  • ON THIS PRODUCT IT DOES NO HARM. This is the 240V GU10 version, soa sheet naming GU10 is simply right. The stale document only misleads on the12V MR16 siblings, where it names a lamp base the product does not have.
  • WORTH KNOWING IF YOU COMPARE LISTINGS: the same document appears against several products inthis family, and it is accurate for some of them and not others. Read the title and thevoltage rather than the sheet’s lamp line.
Downward-only, and the case for the quietest version
  • This throws light down the wall and nothing upward. THAT IS THE VERSION LEAST LIKELY TO CAUSE A PROBLEM.
    • Nothing goes into the sky, so it does not contribute to light spill or annoy aneighbour.
    • Nothing is aimed at eye level from across a boundary.
    • The beam cannot be knocked out of alignment, because it does notadjust.
  • ON A BOUNDARY WALL, A SHARED DRIVEWAY OR A DENSE STREET, THAT MATTERS MORE THAN THEEFFECT. An up/down fitting on a party wall is a complaint waiting to happen; adownward-only one is not.
  • THE EFFECT IS A SCALLOP OF LIGHT on the wall beneath the fitting, widening toward theground. Mounted at around 2m it lights a doorway or a path edge usefully andreads as deliberate.
Bronze and brass the two that change

Both are solid metal finishes rather than coatings, so nothing chips and nothing corrodes froma chip outward. Both patina: brass from bright through brown-gold to darker, bronzedeepening. If a consistent appearance over years is wanted, these are the wrong finishesand powder-coated black or white is the honest answer. Patination is not a fault and isnot covered by any warranty. Mount several in comparable exposure or accept that asheltered one will diverge from an exposed one.

240 V GU10 the least complicated exterior light there is

No driver, no low-voltage cable sizing, no box to house and keep dry. For one or two fittings that simplicity is worth more than anything the 12V versionoffers. The 12V siblings earn their place on a run of five or more along a facade,where one driver serves them all and mains stays out of the wall. 2 the tricolour GU10 lamp is included; 35W is the holder ceiling and the supplied lampdraws far less.

IP65 and the thing that actually determines it

IP65 is dust-tight and protected against water jets from any direction driving rain,hosing and run-off, which is the whole realistic exposure for a wall fitting. BUT THE RATING IS A PROPERTY OF THE INSTALLATION, NOT JUST THE FITTING. A gasket that is not seated evenly against an uneven render or rough brick face gives you IP65on paper and something less in practice. Check the mounting face is flat, or pack it sothe gasket compresses evenly all round. It is the single most common reason an exteriorfitting fails early.

What is published
Specification Value
Sheet lamp line GU10 correct for this product
Same sheet on siblings Misleading on the 12V MR16 versions
Lamp base GU10, 240V no driver required
Lamp included Tricolour, switchable
Direction Downward only nothing into the sky
Max lamp 35W holder ceiling
IP rating IP65 and only as good as the gasket seating
Finishes Bronze Brass solid, they patina
Mounting height ~2m for a doorway or path edge
Warranty 3 years sheet prose
Where it works
  • Boundary walls and party walls nothing upward.
  • Doorways and path edges around 2m.
  • Dense streets the least complaint-prone version.
  • Not where a consistent finish is wanted these patina.
  • Not on an uneven face without packing the gasket.
Specifying it

Downward exterior wall light, IP65. 240V GU10, 35W maximum holder rating, no driverrequired. Tricolour lamp included. Bronze or brass. 3-year warranty. ITS SHEET NAMES GU10 ONLY, AND HERE THAT IS CORRECT the one-light sheets in this family are astale revision that never picked up the 12 V option, but this IS the 240 V GU10 version, so the documentdoes no harm. It only misleads on the MR16 siblings. DOWNWARD-ONLY IS THE VERSION LEAST LIKELY TO CAUSEA PROBLEM: nothing into the sky, nothing at eye level across a boundary, and a beam that cannot be knockedout of alignment. IP65 IS A PROPERTY OF THE INSTALLATION a gasket not seated evenly on rough rendergives IP65 on paper and less in practice.

Supplied and supported by Lights For You.

Questions

Is the datasheet right for this product?

Yes. The one-light sheets in this family name GU10 and never MR16, which is a stale revision they were not updated when Domus added the 12V option. But this is the 240V GU10 version, so a sheet naming GU10 is simply right. The stale document only misleads on the 12V MR16 siblings.

Should I worry about it when comparing listings?

A little. The same document appears against several products in this family and is accurate for some and not others. Read the title and the voltage rather than the sheet’s lamp line.

Why choose downward-only?

It is the version least likely to cause a problem. Nothing goes into the sky, so it does not contribute to light spill or annoy a neighbour; nothing is aimed at eye level from across a boundary; and the beam cannot be knocked out of alignment because it does not adjust. On a boundary wall, a shared driveway or a dense street, that matters more than the effect.

What does the light look like?

A scallop on the wall beneath the fitting, widening toward the ground. Mounted at around 2 metres it lights a doorway or a path edge usefully and reads as deliberate.

Bronze or brass will they stay looking like that?

No. Both are solid metal finishes rather than coatings, so nothing chips but both patina: brass from bright through brown-gold to darker, bronze deepening. If a consistent appearance over years is wanted, these are the wrong finishes and powder-coated black or white is the honest answer. Patination is not a fault and is not covered by any warranty.

Do I need a driver?

No. It is 240V GU10 no driver, no low-voltage cable sizing, no box to house and keep dry. For one or two fittings that simplicity is worth more than anything the 12V version offers. The 12V siblings earn their place on a run of five or more, where one driver serves them all.

What actually determines whether IP65 holds?

The installation. IP65 is dust-tight and protected against water jets, which covers the realistic exposure for a wall fitting but a gasket that is not seated evenly against uneven render or rough brick gives you IP65 on paper and something less in practice. Check the mounting face is flat, or pack it so the gasket compresses evenly all round. It is the single most common reason an exterior fitting fails early.

Only logged in customers who have purchased this product may leave a review.

Shipping policy for our store

We offer fast and reliable shipping worldwide. All orders are carefully packaged and shipped within 1–3 business days after payment confirmation.

  • Fast shipping within 1-3 business days
  • Free shipping on orders over $40
  • 30 days money back guarantee
  • 24/7 online customer support
  • Secure packaging & safe delivery

Standard shipping, expedited shipping and express delivery options are available at checkout. Delivery time depends on your destination country and local logistics.