Your shopping cart is empty!
The EVA glass pendant is a single-lamp glass pendant 255mm glass, 1,200mm drop, E27,240V, IP20, on a black suspension.
The 20W LED maximum sounds restrictive against 40W incandescent, and it isnot. A 20 W LED LAMP PRODUCES ROUGHLY 2,000 LUMENS more than a 100 Wincandescent, and about five times what a 40 W one gives. The maxima are heat limits, sothe more efficient the lamp the more light the same limit allows. In practice apendant like this wants far less: 810W (about 8001,000lm) suits ahallway or a bedside, and 1015W suits a kitchen bench. The 20 W ceiling is unlikely to constrain you.
IP20 means no protection against water at all indoor use only, andnot over a bath, a shower or an exposed outdoor entry. The suspension is1,200mm, which is a starting length rather than a fixed one on most pendants of thistype; ask us if you need it shortened. OVER A BENCH OR TABLE, AIM FOR THE BOTTOM OF THEGLASS AT ABOUT 750900mm ABOVE THE SURFACE low enough to feel intentional,high enough to see across. From a 2.7m ceiling a full 1,200mm drop puts theglass bottom at roughly 1.25m, which is too low over a walkway and about right over abench.
| Specification | Value |
|---|---|
| Record wattage | 25W its sheet’s LED maximum is 20W |
| Measured | The ONLY product whose record exceeds its stated LED max |
| The real maxima | 40W incandescent 20W CFL 20W LED |
| Why the limit exists | Heat, not brightness an enclosed pendant traps it |
| And 20W LED is generous | ~2,000lm more than a 100W incandescent |
| In practice use | 810W hallway or bedside 1015W bench |
| Lamp base | E27 not included |
| Glass | Opal diffuses smoke shows the lamp and cuts output |
| Glass / drop / IP | 255mm 1,200mm IP20, indoor only |
| Warranty | 3 years |
Single-lamp glass pendant. 255mm glass, 1,200mm suspension, 330mm overallwidth. E27, lamp not included. 220240V. IP20, indoor only. Smoke or opal glass on a blacksuspension. 3-year warranty. Maxima: 40W incandescent, 20W CFL, 20W LED. ITS RECORD PUBLISHES 25 W AGAINST ITS OWN SHEET’S 20 W LED MAXIMUM and across everylamp-holder product whose sheet states an LED maximum, this is the only one whose record exceeds it.Anyone reading the record as a guide would fit a lamp above what the fitting allows. The maximum is a HEATlimit, not a brightness one: an enclosed glass pendant traps heat around the lamp, and exceeding itshortens the lamp’s life first and degrades the lampholder and flex after that. IN PRACTICE THE CEILINGWILL NOT CONSTRAIN YOU a 20 W LED lamp gives roughly 2,000 lumens, more than a 100 W incandescent, and apendant like this wants 8 to 15 W.
Supplied and supported by Lights For You.
What wattage lamp can I fit?
Up to 40W incandescent, 20W CFL or 20W LED those are the datasheet’s three maxima. Ignore the 25W in the product record: it is not any of the three figures and it exceeds both the LED and CFL limits.
Is that error common?
No. Across every lamp-holder product whose sheet states an LED maximum, exactly one has a record wattage that exceeds it, and this is that one. It is a specific correction rather than a systemic problem.
Why does the maximum matter?
It is a heat limit, not a brightness one. An enclosed glass pendant traps heat around the lamp, and the maximum is set by what the lampholder, the flex and the glass can tolerate over years. Exceeding it shortens the lamp’s life first and degrades the lampholder and flex insulation after that.
Is 20W of LED enough?
More than enough. A 20W LED lamp produces roughly 2,000 lumens more than a 100W incandescent, and about five times what a 40W one gives. The maxima are heat limits, so the more efficient the lamp the more light the same limit allows. In practice a pendant like this wants far less: 8 to 10W for a hallway or bedside, 10 to 15W over a kitchen bench.
Why does the record have a wattage at all?
Because the field exists, not because the number means something. A pendant with a lampholder has no fixed load the load is whatever lamp you put in it so a single power_watt figure is answering the wrong question. Of 90 lamp-holder products publishing a wattage, 25W is the commonest value at 22% with 60W next at 19%, which is suggestive of a template default rather than proof of one. On any lamp-holder fitting, read the datasheet’s maximum instead.
Opal or smoke?
Opal diffuses and smoke does not, so they do different jobs. An opal pendant is a soft glowing object that can light a space; a smoke pendant is a lamp seen through tinted glass, with the filament or LED array visible. That makes the lamp choice matter much more on smoke use a decorative filament-style lamp, because a bare LED array behind clear-ish glass looks like hardware. Smoke also cuts output substantially, so if the pendant is meant to light something rather than just be seen, choose opal.
How low should it hang?
Over a bench or table, aim for the bottom of the glass at about 750 to 900mm above the surface low enough to feel intentional, high enough to see across. From a 2.7m ceiling the full 1,200mm drop puts the glass bottom at roughly 1.25m, which is about right over a bench and too low over a walkway. Ask us if you need the suspension shortened.
Only logged in customers who have purchased this product may leave a review.
We offer fast and reliable shipping worldwide. All orders are carefully packaged and shipped within 1–3 business days after payment confirmation.
Standard shipping, expedited shipping and express delivery options are available at checkout. Delivery time depends on your destination country and local logistics.