The Felton WBA is a 395mm arm wall light on a black base with aninterchangeable glass shade one G9 globe to 6W, notsupplied in six glass finishes.

An arm, which is what distinguishes this from the rest of the range

The Felton pendants and table lamps hold their glass close to the fitting. TheWBA carries it on an arm, 395mm tall and 185mm out so the shade sits away from the wall, out over whatever is below it. Beside abed, a chair or a picture that is the difference betweenlighting the wall and lighting the thing.

Six glass shades, and they swap

The same six finishes as the rest of the Felton range, and they areinterchangeable the fitting is not fixed at purchase:

• Opal Matt fully diffusing; the only one thathides the globe completely, and the softest light of the six.
• Frost Tear frosted teardrop; diffuse, brighter than opal.
• Smoke and Smoke Tear grey-tinted; darker, and againsta black base the contrast is subtle rather than strong.
• Amber Tear warm-tinted; the warmest light of the six.
• Clear Prism faceted and clear; sparkles and throwspatterns, and shows the globe.

On an arm fitting the choice matters more than on a pendant, becausethe shade is at eye level rather than above it. If it sits beside a bed,Opal Matt is the one that will not glare.

Assembly is required, and only the pages rawspecification block said so it is not in our record. It is alsoClassI earth required, with no lead and plug andinstallation by a licensed electrician only. So: it arrives to be puttogether and then hard-wired, which is worth knowing before the electricianarrives.

Dimming is globe dependent, whatever our record says. Therecord carries No; the pages own block saysGlobe Dependant the same contradiction found on the Feltonmarble table lamps. Fit a dimmable G9 and a wall dimmer and it dims; a plain globewill not.

The globe is not supplied

One G9 to 6W, your choice and if you pickClear Prism or one of the tinted teardrops, buy a decorative one,because those shades show it.

Our datasheet does not confirm this SKU. Ask us if anyspecification is critical to your job.

Where it works

• Beside beds and reading chairs the arm reaches out over them.
• On pictures and artwork.
• With a matching Felton pendant or table lamp in the same glass.
• The shade is at eye level choose Opal Matt beside a bed.
• Assembly required, then hard-wired by an electrician.

Specifying it

395mm high by 185mm out, in glass and iron, black.One G9 globe to 6W, not supplied;dimming is globe dependent. Assembly required. 240V~50Hz,ClassI earth required,no lead and plug licensed electrician only,IP20 indoor and dry locations only. RCM approved. Warranty is three years,as a replacement warranty.

Supplied and supported by Lights For You.

Questions

How far does the arm reach?

185mm out, on a fitting 395mm tall. That puts the shade away from the wall and out over whatever is below it beside a bed, a chair or a picture, that is the difference between lighting the wall and lighting the thing.

Which shade should I choose?

On an arm fitting the shade is at eye level rather than above it, so it matters more than on a pendant. Beside a bed, Opal Matt is the one that will not glare it is the only one of the six that hides the globe completely.

Can I change the shade later?

Yes all six glass finishes are interchangeable across the Felton range, so the fitting is not fixed at purchase.

Does it need assembling?

Yes, and only the pages raw specification block said so it is not in our record. It arrives to be put together and then hard-wired, which is worth knowing before the electrician arrives.

Can I dim it?

It depends on the globe. Our record says No while the pages own block says Globe Dependant the same contradiction found on the Felton marble table lamps. Fit a dimmable G9 and a wall dimmer and it dims.

Is a globe included?

No. One G9 to 6W, your choice and if you pick Clear Prism or a tinted teardrop, buy a decorative one, because those shades show it.

Do I need an electrician?

Yes Class I, earth required, no lead and plug, and Telbix records installation by a licensed electrician only.