Welcome To our shop !

Maxi 600 316 Stainless Steel Louvred

$130.5 $261
SKU: KO80391101440
Availability: in Stock

This is the fullest specification on the Mini/Maxi platform: the tallest body, the louvredhead and the finish with no coating on it. It is also the one most often cross-shopped…

Qty:

This is the fullest specification on the Mini/Maxi platform: the tallest body, the louvredhead and the finish with no coating on it. It is also the one most often cross-shopped onnumbers, so here is what is actually measured and what each figure changes on site.

Output, and the thing the numbers do not say

The 240 V AC model runs a 9 W E27 tri-colour globe at700 lm (3000K), 720 lm (4000K) and 740 lm (5500K). The 12 V DC modelruns a 5 W MR16 at 270 lm, 285 lm and 300 lm. Both rise slightly asthe colour gets cooler, which is normal and worth knowing if you are comparing against ranges where themiddle setting is the brightest. What the lumen figure does not capture is that the louvres put far moreof that output on the ground than a frosted diffuser does, so a louvred fitting is usually more usefulthan an equally-rated plain one at the same height.

The numbers that decide the installation
  • 600 mm tall, 102 mm body, 98 mm base plate with four 6 mm fixing holes and a16 mm cable entry. The plate goes on concrete or a concrete pad, above ground level, everythingsiliconed a stated warranty condition.
  • IP54 splash protection and IK08 impact. IP54 is not immersionprotection; keep it out of anywhere that holds water.
  • Class I on 240 V AC with an earth, Class III on 12 V DC with asuitable 12 V DC LED driver and no direct connection to 240 V. Low voltage runs arecapped at 25 m from the driver with the supply within 5%.
  • 15 W maximum globe, LED only; CRI >80;>30,000 hrs lamp expectancy; parallel wiring; not dimmable with the globes supplied.The optional HV9507 tri-colour MR16 is 12 V DC and 60, against thesupplied globe’s 120.
The finish, and the one obligation attached to it

Bare 316 stainless steel is the most corrosion-resistant material in this range andthe one that shows neglect soonest. Havit asks for maintenance every six months, or morefrequently in coastal environments, to preserve appearance and warranty, and recommends itsHV9971 kit. The installation sheet states the consequence directly: regular cleaningis required to avoid tea staining, and tea staining is not covered by the warranty.Backed by a 3 Years Replacement warranty, with the HV1607 spikeavailable where a footing is impractical.

If you are specifying a mixed run of these and the plain version, Lights For You will help you placethem so the louvred ones land where the glare would otherwise be.

Questions

How does it compare with the plain stainless Maxi 600?

Identical output, identical ratings, identical body the difference is a clear diffuser with louvres in place of a frosted one. The louvred version pushes light down and hides the source, so it suits positions in a sightline. The plain one reads as a soft point of light, which is sometimes exactly what you want.

Which colour temperature is brightest?

5500K, at 740 lumens on the 240 V globe and 300 on the 12 V one. Both triples climb slightly as the colour gets cooler. That is worth checking rather than assuming, because several ranges peak at 4000K instead and the difference matters when you are comparing on paper.

What does the 12 V model need to run?

A suitable 12 V DC LED driver, and the fitting must sit within 25 metres of it with the supply within 5%. It is Class III so no earth is needed at the fitting, but it must never be connected directly to 240 V. Havit treats the distance and tolerance as warranty conditions.

Can I fit a different globe?

Yes, up to 15 watts and LED only. Havits own HV9507 tri-colour MR16 is the listed 12 V DC option in 3 W, 5 W and 7 W, and it has a 60 beam against the 120 of the globe supplied a much tighter pool, which can be exactly right or completely wrong depending on the spacing.

How much maintenance does bare 316 stainless need?

A clean every six months, and more often in coastal environments, with Havits HV9971 kit recommended for the job. This is a warranty matter rather than a cosmetic one: tea staining is specifically excluded from cover, and regular cleaning is what prevents it.

Is IP54 a problem for an outdoor fitting?

It is lower than people expect, so it is worth knowing. IP54 covers splashing water from any direction rain, sprinkler overspray, a hose passing by but not jets and not standing water. Mount it on its base plate above ground level, seal the cable entry, and keep it out of low spots that puddle.

Does it come with everything needed to install it?

It comes with the base plate, the IP-rated junction box inside the fitting and the tri-colour globe for the part number you order. What you supply is the concrete or concrete pad, the silicone, appropriate fixings for the location, and on the 12 V model the LED driver.

Only logged in customers who have purchased this product may leave a review.

Shipping policy for our store

We offer fast and reliable shipping worldwide. All orders are carefully packaged and shipped within 1–3 business days after payment confirmation.

  • Fast shipping within 1-3 business days
  • Free shipping on orders over $40
  • 30 days money back guarantee
  • 24/7 online customer support
  • Secure packaging & safe delivery

Standard shipping, expedited shipping and express delivery options are available at checkout. Delivery time depends on your destination country and local logistics.