Your shopping cart is empty!
The 510mm Noyer is where this range stops being a ceiling light and starts being the feature of the room. It is a 510mm ring of real walnut over an aluminium chassis, still only 80mm deep, with a polycarbonate diffuser across the face. On a white ceiling it reads as a disc of timber; lit, the whole face glows rather than showing a bright spot in the middle.
It produces 3,5003,700lm across a 120 spread. That is a genuine single-fitting solution for an open living room, a large main bedroom, or a dining space where you would otherwise run four or five downlights. Where it earns its keep is exactly there replacing a grid of downlights with one soft source removes the scalloping on the walls and the shadows under people’s eyes that a downlight array creates.
Havit states it plainly on the sheet: walnut varies in colour, grain, texture and tone, and knots, mineral streaks and colour variation are natural characteristics rather than defects. On a 510mm ring there is a lot of timber on show, so expect the grain to be part of the look rather than an even stain.
Selected at installation from a switch inside the fitting: 3000K, 4000K or 5500K. 4000K is the brightest at 3,700lm, with 5500K at 3,600lm and 3000K at 3,500lm so the coolest setting is not the strongest, and the warm setting costs about 5% of the output. In a living room with timber and soft furnishings, 3000K is usually the right answer.
This is an IP20 indoor fitting and it is Protection Class 1, so an earth must be connected at the fitting worth flagging to your electrician, since most surface oysters they handle are Class 2. It takes 240V AC directly, with no driver to conceal above the ceiling, and it is Triac dimmable with Havit’s HV9625 300W LED dial dimmer as the matched control. Impact rating is IK05, colour consistency SDCM<6, glare UGR<25, and the warranty is 3 years replacement. Lights For You keeps every Noyer diameter in stock in both ceiling and suspended form, so you can put the same timber above a table and flush to the ceiling in one project.
Can this replace a set of downlights?
That is what it is for. 3,5003,700lm from one 120 source lights an open living or dining room without the wall scalloping and hard shadows a downlight grid produces. Your electrician can usually run it off one of the existing points.
How much brighter is it than the 420mm?
About 15% 3,5003,700lm against 3,0003,200lm. The bigger difference is the spread of the source: a wider face means softer shadows, which is more noticeable in a room than the lumen figure.
Does it need an earth?
Yes. Havit specifies Protection Class 1 across the Noyer range, so an earth connection is required at the fitting.
Which colour temperature gives the most light?
4000K, at 3,700lm. 5500K gives 3,600lm and 3000K gives 3,500lm, so output peaks at the middle setting rather than the coolest one.
Is the timber real?
Yes walnut timber over an aluminium chassis. Havit notes that variation in colour, grain, texture and tone, along with knots and mineral streaks, is inherent to the material and is not treated as a fault.
Can it be used outdoors or in a bathroom?
No. It is IP20 and specified for indoor use only. Neither the rating nor the timber suits a wet or exposed position.
Will it dim smoothly?
It is Triac dimmable and Havit pairs it with the HV9625 300W LED dial dimmer. As with any LED, the quality of the low end depends on the dimmer a matched Triac control will hold a lower level than an unbranded phase-cut unit.
Only logged in customers who have purchased this product may leave a review.
We offer fast and reliable shipping worldwide. All orders are carefully packaged and shipped within 1–3 business days after payment confirmation.
Standard shipping, expedited shipping and express delivery options are available at checkout. Delivery time depends on your destination country and local logistics.