The Revo is a two-head adjustable exterior wall light with a built-in sensor, which puts it in a specific job category: the fitting you mount at a side gate, a back door or a garage wall that should be dark until something moves. Both heads aim independently, so one can cover a path while the other watches a driveway, and at 29W it is bright enough to be a genuine security light rather than a courtesy one. It is rated IP65 for direct rain and comes in black or white. There is no globe to buy or replace the LED is built in.

The choice to make

Finish is the only purchase choice: HV3684T-BLK in black or HV3684T-WHT in white. Everything else is set on the fitting. The colour temperature is tri-colour selectable and output rises as the light cools: 2810lm at 3000K, 2850lm at 4000K and 2900lm at 5500K. For a security position, 5500K reads brighter and more alert; at a back door used nightly, 3000K is easier to live with. The beam is a wide 120.

Where it works

• Garage and carport walls, covering the door and the apron in one fitting.
• Side gates and service paths down the boundary of a suburban block.
• Back doors and laundry entries where hands-full arrivals need automatic light.
• Rear yards and shed walls, with the two heads split between the path and the open ground.

Specifying it

The Revo is a 240V fitting and wires straight to mains no driver or transformer is required. The LED is built in, so no globe is needed and none can be fitted; when the LED reaches end of life the fitting is replaced rather than re-lamped. The body is powder-coated aluminium, rated IP65, which means it can be mounted on an exposed facade in direct rain rather than needing an eave. Total draw is 29W. It is not dimmable with a sensor-controlled fitting that is rarely a limitation, since the sensor governs switching.

Supplied by Lights For You the Revo’s sensor and its two aimable heads need to be set together, so have your electrician walk the approach and adjust the detection zone and both beams on the same visit.

Coastal siting Havits condition

Havits installation instructions for this fitting state that aluminium and 304 stainless steel fittings must not be installed within 5 km of any salt water environment. That is a condition on where the fitting may go, and it sits beside the IP rating rather than inside it: a fitting can be rated for direct rain and still fall outside this rule, because the issue is salt carried in the air rather than water landing on the surface. If your site is inside that zone, talk to us before you specify it Lights For You can point you at a fitting whose material Havit does not name here.

Earthing and protection class

This fitting runs on 240 V AC mains and is Protection Class 1 an earth is required at the fitting. Havit’s installation sheet has the installer connect the earth conductor first, then live and neutral.

Questions

Does it need a globe?

No. The LED is built in, so no globe is needed and none can be fitted.

Does it need a driver or transformer?

No. It is a 240V fitting and wires directly to mains.

Can it be mounted where rain hits it directly?

Yes for rain it is rated IP65, which covers direct rain and driven spray. Salt is a separate question: Havits installation instructions say aluminium and 304 stainless steel fittings must not be installed within 5 km of any salt water environment.

How bright is it?

2810lm at 3000K, 2850lm at 4000K or 2900lm at 5500K, from 29W with a 120 beam.

Can I aim each head separately?

Yes. Both heads adjust independently, so you can cover two different areas from one mounting point.

Is it dimmable?

No. Switching is handled by the built-in sensor.

What finishes are available?

Black (HV3684T-BLK) and white (HV3684T-WHT), in powder-coated aluminium.

What warranty does it carry?

A 3-year replacement warranty.