Welcome To our shop !

Slim White Dimmable 200mm Surface Mounted Slim Oyster Light

$33 $66
SKU: KO80391096462
Availability: in Stock

The Slim is the flattest ceiling light Havit makes: a polycarbonate disc 26mm deep whose whole face lights up, so it reads as part of the ceiling rather than as…

Qty:

The Slim is the flattest ceiling light Havit makes: a polycarbonate disc 26mm deep whose whole face lights up, so it reads as part of the ceiling rather than as a fitting hanging off it. This is the smallest of the four sizes, and its data sheet measures the body at 210mm the listing name rounds that to 200mm, so allow the full 210mm when you are working to a tight ceiling detail.

What a 16W oyster will light

It puts out 1,4001,500lm, which is the right amount for a hallway, a laundry, a walk-in robe, a small bathroom or a stair landing rooms where you want the ceiling clear and the light even rather than dramatic. For a bedroom or a living room the 24W and 30W bodies in the same range are the better match; they are the same 26mm depth, so going bigger costs width and nothing in ceiling presence.

Colour temperature, and which setting is actually brightest

A slide switch in the base selects 3000K, 4000K or 5500K and is set once at installation. Output is not a ladder: 4000K is the brightest at 1,500lm, 5500K gives 1,450lm and 3000K gives 1,400lm. If you want the most light out of the fitting, choose the middle setting rather than the coolest one.

Colour quality

Havit rates this model at CRI>90 with SDCM<3 and UGR<25. CRI>90 matters in a bathroom or a robe, where you are judging skin tone and the colour of clothes; SDCM<3 means two of these installed side by side in a hallway will look like the same white, which is the fault people notice long before they notice a lumen difference.

Where the IP54 rating applies and where it does not

It is IP54 and IK06, and Havit attaches one condition to that in writing: if it is installed on any surface other than a ceiling a wall, for instance the rating drops to IP20. So it is a ceiling fitting for a bathroom or laundry, and it is not a wall fitting for a wet area at all.

Installation

Surface mounted, so there is no cutout. The base plate is 164mm with two fixing holes, and the body twists onto it. It runs on 240V AC with no separate driver, and is Protection Class 2, so no earth is required at the fitting. The supplied male and female connector must not be removed. It is Triac dimmable, with Havit’s HV9625 listed as the matched dimmer, and carries a 3 years replacement warranty. Lights For You stocks the whole Slim range, so the size can be chosen against the room rather than against a catalogue photo.

Questions

Do I need to cut a hole in the ceiling?

No. It is surface mounted. The 164mm base plate screws to the ceiling through two fixing holes, the supply cable comes through the centre, and the 210mm body twists onto the plate. Nothing recesses into the ceiling cavity.

Can it go in a bathroom?

On the ceiling, yes it is IP54, which covers dust and splashing water. Havit states in the installation instructions that mounting it on any surface other than a ceiling downgrades the rating to IP20, so it should not be used on a bathroom wall. Your electrician will place it against the AS/NZS 3000 zones for the room.

Which colour setting gives the most light?

4000K, at 1,500lm. 5500K gives 1,450lm and 3000K gives 1,400lm, so the brightest setting is the middle one, not the coolest. The difference is small enough that you should choose on the look you want.

Can I change the colour temperature later?

Yes, but not from below. The slide switch sits in the base of the fitting, so the body has to be twisted off the plate to reach it. Decide the setting before the electrician leaves, or expect to take it down again.

Does it need an earth?

No. The body and diffuser are polycarbonate and Havit specifies it as Protection Class 2, so no earth connection is required at the fitting itself.

Will it work on my dimmer?

It is Triac dimmable and Havit lists the HV9625 as the matched control. A 16W load is small, so if it is the only fitting on the circuit check the dimmers minimum load an underloaded Triac dimmer is the usual cause of flicker at the bottom of the range.

Why does the title say 200mm when the specification says 210mm?

210mm is the figure on the data sheet and on the installation drawing; 200mm is the rounded name the range is sold under. Work to 210mm if you are lining the fitting up with a tile joint, a bulkhead or another light.

Only logged in customers who have purchased this product may leave a review.

Shipping policy for our store

We offer fast and reliable shipping worldwide. All orders are carefully packaged and shipped within 1–3 business days after payment confirmation.

  • Fast shipping within 1-3 business days
  • Free shipping on orders over $40
  • 30 days money back guarantee
  • 24/7 online customer support
  • Secure packaging & safe delivery

Standard shipping, expedited shipping and express delivery options are available at checkout. Delivery time depends on your destination country and local logistics.